广东11选5

双组份涂胶机流水线作业的生产需求

发布时间:2018/03/13    发布人:

双组份涂胶机是生产中空、幕墙玻璃的专用设备,可一次完成二道密封中A、B组份混合与涂胶。适用配比精度高的胶种,满足玻璃深加工企业高、高合格率流水线作业的生产需求,是大规模生产高档优质中空玻璃及玻璃幕墙产品的一种理想的配套设备,调节减压阀至0.4~0.6Mpa,检查系统有无漏气现象。然后试运行以下动作:(1)A泵提升;(2)A泵充气;(3)B泵提升;(4)B泵充气。注意:提升气缸提升时,如果两气缸不同步,请下降至原点后重新操作。
The double component coating machine is a special equipment for producing hollow and curtain wall glass. It can be used in two seals at one time to mix and glue A and B components. Suitable ratio of high precision rubber, meet glass deep-processing enterprises with high efficiency and high qualification rate of the production line operating needs, is an ideal equipment for mass production of high quality hollow glass and glass curtain wall products, regulating valve to 0.4~0.6Mpa, check system has no leakage. Then try to run the following actions: (1) A pump lifting; (2) A pump inflated; (3) B pump lifting; (4) B pump inflated. Note: when lifting the cylinder, if the two cylinder is not synchronized, please drop back to the original point and re operate.
2、将A、B组份胶桶就位,并与A、B胶泵的轴线对中。
2, the A, B component glue barrel is in place, and the axis of A, B glue pump is in the center.
以A组份为例:
Take A as an example:

双组份打胶机
1)操作手动转阀,将A泵提升至高,提升过程中观察各管路有无拉伸过紧处。
1) operate the manual transfer valve to elevate the A pump to the highest level.
2)将胶桶放置在A泵压胶盘下,开启胶桶,将其中塑料袋外翻至桶外,胶面塑料片取出。
2) put the glue barrel under the A pump press disc, open the glue barrel, turn the plastic bag out to the bucket, and take the plastic sheet out.
3)使A泵压盘缓慢下降,压盘入桶时应使其与桶口对准,将压胶盘排气口打开,直到压盘接触胶面。待压盘内气体全部排放完并有少量胶从排气口溢出时,即可关闭排气阀。(提升开关保持下压状态)
3) slow down the pressure plate of the A pump, when the pressure plate enters the barrel, it should be aligned with the buckets, and the vent opening of the press disc is opened until the press disc is exposed to the rubber surface. The exhaust valve can be closed when the gas is completely discharged and a small amount of glue is spilled from the exhaust port. (lift switch keep down pressure state)
4)开机试打胶:将主泵气源开关打开,按下胶枪开关,直至A泵里空气排净枪口处出胶连续时停止。
4) open machine test glue: open the main pump gas switch, press the glue gun switch until the air in the A pump is discharged at the mouth of the gun and stops when the glue is continuous.
本文的精彩内容来自双组份打胶机详细内容请点击我们的官方网站: http://www.tbplay265.com谢谢您的到来!
The wonderful content of this article comes from the detailed content of the double component glue machine, please click on our official website: http://www.tbplay265.com thank you for your arrival!

广东11选5 广东11选5走势图 麒麟棋牌 广东11选5走势图 广东11选5 麒麟棋牌下载 大圣棋牌 大圣棋牌 广东11选5 广东11选5