Even for professionals, the two - component punch actually stays in its actual use。 However, it is difficult to understand the glue machine at its level of use。 So, what are the requirements for the workshop environment of the horizontal sizing machine?
The requirement of the ground roughness of the glue machine, which is the most frequently asked question of our factory's participation in the Beijing international glass exhibition in the near future。 Small horizontal gluing machine for surface roughness requirements are not very high, in the initial stage of our equipment R & D engineers have taken into account the flatness of the ground problem so solving this problem is the focus in the process of research and development。
We have added a special device in the equipment to solve the impact of the ground roughness on the gluing machine。 Of course this small would like to emphasize that although smooth equipment on the ground of requirements is not high, but not everywhere is bumpy。
First of all, let's talk about the requirements of the site area, horizontal gum machine is different from the vertical rubber machine. Vertical glue machine for the factory area requirements are relatively high, conservative estimate also need to do 50 square meters of place. Small glue machine for plant area requirements will be much smaller, only less than 10 square meters of the place can be stored, the main equipment is due to small size can be arbitrarily placed, do not need to make room for gluing machine.
Then we say glue machine for workshop temperature and humidity requirements, as the equipment in terms of atx-ii itself for the workshop temperature is not high, the general should be installed in a dry, no dust, no corrosive gas, temperature 0 ~ 40 degrees in the workshop. There is little difference between the requirements of other equipment.
In this paper, a two component glue machine to provide you, our website is: http://www.tbplay265.com, we will wholeheartedly provide you with better service, you are welcome to visit!