广东11选5

导致中空玻璃打胶机密封不严的方法

发布时间:2017/12/21    发布人:

  双组份打胶机结构较为复杂分为电气部分以及供胶部分购买前一定要将这些部分全部检查完毕,以免后续出现各种故障。
  The two component glue machine is complex. It is divided into electrical parts and the supply parts. All parts must be checked before they are purchased, so as to avoid any subsequent failures.
  首先我们要检测导轨、铝槽、滑动轴承部分,这部分平时如果收到过撞击等很容易变形损坏,即便是一些微小的变形也可能导致设备工作不正常如打胶机的电机时快时慢,打胶质量差等问题。
  First of all we want to detect guide, aluminum groove and sliding bearing part, this part usually if the received impact is easy to deformation and damage, even a minor deformation may also lead to the electrical equipment does not work properly such as glue machine speed, such as the poor quality of glue.
  检测双组份打胶机的供胶管路是否通畅,混交棒是否完好。因为我们使用胶体的特质决定的供胶管路非常容易杜塞,如果对方平时没有注意对设备保养那么有很大的可能会堵塞、混交棒损坏,如果这部分损坏的话设备的出胶量会变得不正常甚至会出现花胶的情况出现。

双组份打胶机
  Whether the glue supply line of the double component glue machine is unobstructed and the mixed stick is good. Because we use the glue line colloid characteristics determine very easily Dusseldorf, if you usually do not pay attention to equipment maintenance so great may be blocked and mixed rod damage, if this part of any equipment to produce the adhesive will become normal or even a flower gum situation.
  打胶机的供娇压力如果不够的话也是会出现这个问题的,因为打胶机的胶体完全靠气压来挤出设备并完美的涂装在中空玻璃的铝条中的。如果压力过小的话也会导致中空玻璃打胶机密封不严。所以我们一定要检测下我们要购买的双组份打胶机的压力系统是否正常,是否能够正常的调节压力。
  If the pressure of the glue machine is not enough, it will also happen if it is not enough, because the colloid of the glue machine is completely extruded by air pressure and applied to the aluminum strip of the hollow glass perfectly. If the pressure is too small, it will also lead to the tight sealing of the insulating glass machine. So we must check whether the pressure system of the double component glue machine we want to purchase is normal, and whether it can regulate the pressure normally.
  排查检测双组份打胶机的密封圈以及混合器单向阀,这部分如果损坏的话会导致双组份打胶机的aB组份比例不对,出现混乱!同时密封圈也算是比较容易损坏的所以我们应当重点排查。
  Check and check the seal ring and mixer one-way valve of the two component glue machine. If this part is damaged, it will cause the proportion of aB component of the two component glue machine is not correct, there will be confusion. At the same time, the sealing ring is also relatively easy to damage, so we should focus on the investigation.
  本文由双组份打胶机为您提供,我们的网站是:http://www.tbplay265.com我们将以全心全意的热情为您提供更优质的服务,欢迎您的访问!
  This article is provided by two component glue machine. Our website is: http://www.tbplay265.com, we will provide you with better service with wholehearted enthusiasm, welcome your visit.

广东11选5开奖结果 广东11选5 麒麟棋牌 广东11选5 大圣棋牌 麒麟棋牌下载 广东11选5走势图 麒麟棋牌app 立即博 广东11选5开奖结果