The common problems of the butyl rubber coating machine are solved:
The phenomenon of no glue on either side or both sides of the 1. aluminum frame
We should check whether the temperature of the rubber cylinder and the rubber head is normal, whether the pressure is within our range, and check whether the distance between the two rubber heads is too large (the distance is set to the aluminum strip can just pass from the two rubber heads to the best).
If the above conditions are all right, two glue heads (or one) can be determined. Because of the impurities in the butyl rubber, the gel head is blocked out, so we need to remove the rubber head and soak it in kerosene, then clean the glue in the adhesive head and then install it.
2., the hydraulic system is used in all the devices. The oil cylinder and hydraulic system are all connected by high pressure oil pipe. Each connection is sealed by combination gaskets. If we find oil leakage, replace the combination cushion in time.
3. the equipment glue and glue cylinder head heating heating, the heating rod two and a heating plate, a temperature control table to set and adjust the temperature, if the temperature rise is not high or increased after going down, please check the heating rod or the heating disc is damaged, and check whether the normal temperature table.
广东11选5 Customer satisfaction is our affirmation. You are welcome to purchase our company's products. We have always thought that you are responsible for products and have always insisted on doing so. Welcome to your visit.